Q. In which of the following forging process no flash is formed?

  • (A) open die
  • (B) closed die
  • (C) impression dies
  • (D) hold dies
💬 Discuss
✅ Correct Answer: (B) closed die
Explanation: in flashless forging, the work piece is fully restricted within the die and no flash is produced. the amount of initial work piece used must be controlled accurately so that it matches the volume of the die cavity.

Published by Mr. Dubey ⭐ 104.82K Points at 23-Sep-2023 07:30 pm in Process Planning and Cost Estimation

Explanation by: Mr. Dubey
in flashless forging, the work piece is fully restricted within the die and no flash is produced. the amount of initial work piece used must be controlled accurately so that it matches the volume of the die cavity.

💬 Discussion

Related MCQs

Q. The PWM control of DC motor varies

Q. A cubical block rests on an inclined plane of μ = 1/√3, determine the angle of inclination when the block just slides down the inclined plane

Q. Power is transmitted by an electric motor to a machine by using a belt drive. The tensions on the tight and slack side of the belt are 2200 N and 1000

Q. In a simple train of wheels, the velocity ratio __________ the intermediate wheels.

Q. Calculate the average value of the sinusoidal waveform x(t)=848sin(1.65πt+2π÷0.68).

Q. In sensible heating or cooling,

Q. In a Hartnell governor, the stiffness of the spring is given by (where S1 and S2 = Spring forces exerted on the sleeve at max. and min. radii of rotat

Q. The approximate radiographic equivalence factors for steel and copper at 220 kV are 1.0 and 1.4 respectively. If it is desirable to radiograph a 1.27

Q. The most important factor required for the proper interpretation of ultrasonic test results is:

Q. Which of the following area of work needs highest level of illumination?

📊 Question Analytics

👁️
296
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
90%
Success Rate