M

Mr. Dubey • 100.64K Points
Coach

Q. If T1 and T2 are the tensions on the tight and slack sides of the belt respectively and TC is the centrifugal tension, then initial tension in the belt is equal to

  • (A) T1 - T2 + TC
  • (B) T1 + T2 + TC
  • (C) T 1 − T 2 + T C 2
  • (D) T 1 + T 2 + T C 2
  • Correct Answer - Option(D)
  • Views: 911
  • Filed under category Machine Design
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Programming language FOTRAN stands for:

Q. Heat conduction does not occur

Q. A condenser must and then the compressed refrigerant.

Q. Just as strong is opposite of weak likewise elastic is opposite of

Q. According to ASME Section VIII, a linear indication is defined as an indication in which the length is equal to or greater than the width by a factor

Q. For each ton of pig iron produced from blast furnace, the lime stone used is approximately

Q. The included angle in Acme threads is

Q. The obtainable from a certain heat input in a cyclic heat engine is called

Q. The property ensures the removal of excess sand in the mould box.

Q. What is the factor on which, difference between the two heating values of fuel depends on?

Question analytics