📊 Machine Design
Q. The radial distance from the __________ to the clearance circle is called working depth.
  • (A) Addendum circle
  • (B) Dedendum circle
  • (C) Pitch circle
  • (D) None of these
💬 Discuss
✅ Correct Answer: (A) Addendum circle

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The technique of converting metallic powders into articles of definite form is known as

Q. A low density image of the letter ‘B’ on a radiographic film would probably be caused by:

Q. In a tap set, the first tap used in thread cutting is

Q. The machine tool, in which calculation and setting of the operating conditions like depth of cut, feed, speed are done during the machining by the con

Q. 095m, d2=0.06m, d3=0.05m Ma = 900 Kg, Mb = 700 Kg

Q. A DC motor runs at 1725rpm at full load and 1775rpm at no load. The speed regulation is _____.

Q. Most metallic conductors have a

Q. The relation between the pitch of the chain (p) and pitch circle diameter of the sprocket (D) is given by (where T = Number of teeth on the sprocket)

Q. Where does the granular molding material get loaded into?

Q. A 3-phase slip-ring induction motor has ……………… rotor.

📊 Question Analytics

👁️
178
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
81%
Success Rate