M

Mr. Dubey • 100.64K Points
Coach

Q. If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to

  • (A) Diameter of bolt
  • (B) 0.75 × diameter of bolt
  • (C) 1.25 × diameter of bolt
  • (D) 1.5 × diameter of bolt
  • Correct Answer - Option(A)
  • Views: 876
  • Filed under category Machine Design
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. When a longitudinal wave is incident upon an inclined interface and is refracted at ninety degrees, the angle of the incident longitudinal wave is cal

Q. If heat is added to the wet steam temperature _________

Q. The average load factor of thermal power plants in India is

Q. ____ is a highly automated group of GT machine cell.

Q. The angle during which both the inlet and exhaust valves remain open simultaneously, is known as

Q. Approximate cost of sewerage project for a population of one [email protected] Rs. 10/- head works out as Rs. 10 lakh.

Q. When a nut is tightened by placing a washer below it, the bolt will be subjected to following type of loads

Q. A column has its equivalent length equal to its length in case of

Q. Which of the following can be used as an argument for a procedure parameter?

Q. If the pressure drop(ΔP) is 200 units, the flux(J) is 100 units,what is the hydraulic membrane permeability?

Question analytics