Q. The purpose of the UCSICON command is to:?

  • (A) Permit a user to move the UCS system.
  • (B) Permit a user to redefine the location of 0,0.
  • (C) Permit a user to control the placement and appearance of the icon to help you understand your orientation in the XYZ coordinate system.
  • (D) Provide a working plane to draw on.
💬 Discuss
✅ Correct Answer: (C) Permit a user to control the placement and appearance of the icon to help you understand your orientation in the XYZ coordinate system.

Published by Vinay ⭐ 28.75K Points at 17-Feb-2025 06:50 pm in AutoCAD (CAD)

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. It takes 6 hours to dry a wet solid from 50% moisture content to the critical moisture content of 15%. How much longer it will take to dry the solid t

Q. Which law of thermodynamics defines entropy

Q. One British thermal unit (BTU) is nearly equal to

Q. Shrinkage allowance does not depend on which of the following factor?

Q. If during operation a boiler bursts, the matter should be reported to

Q. The main advantage of ac transmission system over dc transmission system is

Q. Contact breaker should be set

Q. Steam turbines are used for ____________

Q. Explicit support structures are not required in Selective Laser Sintering (SLS).

Q. When load is connected to three phase induction motor is increased, then its slip

📊 Question Analytics

👁️
202
Total Visits
📽️
2 y ago
Published
🎖️
Vinay
Publisher
📈
89%
Success Rate