Q. Machining is never used for rapid prototyping because it takes too long.

Related MCQs

Q. The rivet diameter should be

Q. Due to the centrifugal force acting on the rim, the flywheel arms will be subjected to

Q. Two SI engines run at same speed and develop same power but have different compression ratio. The engine with higher compression ratio will have its i

Q. Which of the following enters the super heater of a boiler?

Q. Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surf

Q. Which dimensionless number correlates the relative thickness of the hydrodynamic and thermal boundary layers?

Q. Blow by losses are

Q. Which is the most widely used resin in shell moulding?

Q. ________ is an inversion of Double slider crank chain.

Q. The minimum number of theoretical plates is required for achieving a given separation in distillation column with