M

Mr. Dubey • 100.64K Points
Coach

Q. Which test used for the measuring the workability of the concrete?

  • (A) slump test
  • (B) flow test
  • (C) Kelly ball test
  • (D) all of the above
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Poisson’s ratio of steel is

Q. The compressive strength of an ordinary Portland cement (1 : 3 cement mortar cube) after 7 days test should not be less than

Q. A simply supported rolled steel joist 8 m long carries a uniformly distributed load over it span so that the maximum bending stress is 75 N/mm2

Q. Greater the super-elevation, more will be convenience to the slow moving traffic.

Q. When the concrete mix is too wet, it causes ?

Q. If a hammer is raised by steam and allowed to fall by gravity on top of the pile, it is called as

Q. The cylinder of reciprocating cylinder is made up of

Q. The discharge through a channel of circular section will be maximum when the depth of water is

Q. In flow through pipe bends the pressures on inner and out radii

Q. The force per unit length is the unit of

Question analytics