πŸ“Š Data Communication and Networking
Q. In session layer, during data transfer, the data stream responsible for the "control" purpose (i.e control of the session layer itself) is
  • (A) Regular Data
  • (B) Typed data
  • (C) Capability Data
  • (D) Expedited Data
πŸ’¬ Discuss
βœ… Correct Answer: (C) Capability Data
πŸ“Š Data Communication and Networking
Q. The ________ measures the number of lost or garbled messages as a fraction of the total sent in the sampling period.
  • (A) Residual Error Rate.
  • (B) Transfer Failure Probability.
  • (C) Connection release failure probability.
  • (D) Connection establish.
πŸ’¬ Discuss
βœ… Correct Answer: (A) Residual Error Rate.
πŸ“Š Data Communication and Networking
Q. Start and stop bits are used in serial communication for
  • (A) Error detection
  • (B) Error correction
  • (C) Synchronization
  • (D) Slowing down the communication
πŸ’¬ Discuss
βœ… Correct Answer: (C) Synchronization
πŸ“Š Data Communication and Networking
Q. "BAUD" rate means
  • (A) The number of bits transmitted per unit time.
  • (B) The number of bytes transmitted per unit time.
  • (C) The rate at which the signal changes.
  • (D) None of the above
πŸ’¬ Discuss
βœ… Correct Answer: (C) The rate at which the signal changes.
πŸ“Š Data Communication and Networking
Q. Error detection at the data link level is achieved by
  • (A) Bit Stuffing
  • (B) Cyclic Redundancy Code
  • (C) Hamming Code
  • (D) Equalization
πŸ’¬ Discuss
βœ… Correct Answer: (B) Cyclic Redundancy Code