M
Explanation by: Mr. Dubey
good alignment of each tooth on a gear is essential, as otherwise the load will not be distributed evenly over its face. it is quite probable that the load may be carried by one edge only introducing high bearing stresses, if teeth of a gear are machined poorly.
You must be Logged in to update hint/solution
Related MCQs
Q. Compression ratio for spark ignition engines varies in the range
Q. A series of continuous spot welds
Q. The lines of flux or force in a circularly magnetized ferromagnetic bar:
Q. Which of the following represents the reduction in duration?
Q. Which type of insulators are used on 132 kV transmission lines?
Q. Steady flow process requires that
Q. The air fuel ratio required for the efficient operation of a three approximately
Q. If the sensing element is large, then less amount of heat is required.
Discusssion
Login to discuss.